- 220 – 240 V (50 – 60 Hz) input
- 110 – 277 V input voltage range upon request
- Power factor at full load more than 0,95
- Total harmonic distortion (THD) ≤ 8%
- Up to 99 % driver efficiency at full load with the Philips Xitanium LED driver
- Dimming options: Lumistep, Line switch, DALI, 1 – 10 V and Dynadimmer
(autonomous dimming) upon request - 6 kV differential mode and 8 kV common mode standard surge protection. 10 kV surge protection upon request
- Protection class I or II
- High corrosion resistance
Mechanical characteristics
- Housing made of aluminium (die casted housing)
- Top pole or side entry. As a standard equipped with a 60 mm pole connector, 76 mm also available
- Possibility to change the inclination from -15° up to +15° in increments of 5°
- A cable upon request
- Dust painted with epoxy paint & thermal treatment to ensure long-term environmental protection against all weather conditions. RAL 9006 or other upon request
- All screws are made of stainless steel
- All gaskets are made of ozone and UV resistant material for IP66 protection
- Certified up to IK10
- VERY HIGH LUMEN EFFICIENCY
LED street light LN was designed for robust handling in different kind of environments. LN street lights are IK10 and IP66 certified. This means they can handle high impact resistance and high water and sand resistance. Additionally LN street light can be opened fully without tool requirements and serviced as lighting maintenance companies are used to do. Housing is fully die cast aluminum housing. Because of high lumen efficiencies this light is especially suitable for ESCO model companies who earn from its efficiency and flexibility.
Made in EU.
SMART READY LIGHT
LN street light model can be supplied smart-ready, which means it can be upgraded to smart lighting during the expected lifetime of the luminary. Many municipalities are planning to have their lighting system upgraded to smart in the near future. With smart-ready option users can start saving with LED lights immediately and upgrade to full smart later with help of Luxtella management system or third party management systems.
Optical characteristics
- Standardly we are using PMMA that is 100% UV resistant which prevents against yellowing over the entire life time of the lenses.
- Polycarbonate lenses ensure high impact resistance.
- Photometric files are available upon request.
- There are more than 50 possible optical distribution possibilities. Most common ones are presented below.
| Optic A |
| Optimised for ME and S road classes and narrow roads (IESNA TYPE II) |
| Pole height 4 – 6m, pole spacing from 20 – 30m (S classes), and height from 7 – 12m, spacing from 30 – 40m (ME classes)
|
| Optic G |
| Optimised for ME road classes and wider roads (IESNA TYPE III) |
| Pole height from 7 – 12m, pole spacing from 25 – 45m
|
| Optic C |
| Optimised for S road lighting classes with narrow roads (IESNA TYPE II/III) |
| Pole height from 4 – 8m, pole spacing from 25 – 45m
*upon request available also modified optics C without back spill light |
| Optic N
Wide beam optics (IESNA TYPE II) optimised for long pole distances, pedestrian & bike paths
Pole height from 4 – 9m, pole spacing from 30 – 55m |
| Optic L
Forward-thrown beam optics (IESNA TYPE IV) optimised for wide outdoor areas and parking lots
Pole height from 6 – 12m, pole spacing from 15 – 25m |